Metal DC Geared Motor w/Encoder CQGB37Y001

From CQRobot-Wiki
Revision as of 09:05, 2 April 2018 by Yangguo (talk | contribs)
Jump to: navigation, search
6V/12V Metal DC Geared Motor w/Encoder-CQRDJ-GL

Description

  • This is metal DC geared motor w/Encoder, Operating voltage is 6V-12V. for Projects Such as Robot, Custom Servo, Arduino and 3D Printers.
  • The rear of the motor is equipped with a dual channel Holzer effect encoder, AB dual output, single circuit per cycle pulse 16CPR, double down the road, a total output of 64CPR.
  • These units have a 0.61 inch long, 6 mm(0.24 inch)-diameter D-shaped output shaft. This motor is intended for use at 12V, though the motor can begin rotating at voltages as low as 1V.
  • The face plate has six mounting holes evenly spaced around the outer edge threaded for M3 screws. These mounting holes form a regular hexagon and the centers of neighboring holes are 15.5 mm(0.61 inch) apart.

NOTE

Do not screw too far into the mounting holes as the screws can hit the gears. CQRobot Manufacturer recommends screwing no further than 3mm (1/8 inch) into the screw hole.


Display

Motor2.jpg
Motor3.jpg
Motor4.jpg

Motor5.jpg
Motor6.jpg
Motor7.jpg

DISTRIBUTION LIST

  • 1 * 6V/12V Metal DC Geared Motor w/Encoder